Image send cue

Historical record of a forum that was for discussion of the setup, configuration, and use of OnePacs for research and educational purposes (non-clinical use).

Please direct any support inquiries through the standard OnePacs ticketing and support system.

The "Announcements" forum will continue to be active and contain announcements related to the OnePacs system.
Locked
mindi2210
Posts: 78
Joined: Tue Mar 04, 2014 2:42 pm

Image send cue

Post by mindi2210 » Wed Jul 17, 2019 12:40 pm

We send cases out thru the Gateway VIA a VPN to outside facilities. Is there any place that I can see a cue of what is currently being sent or way to stop a case that is sending? Thru the jmx console maybe?

damien
Posts: 37
Joined: Fri Jun 07, 2013 7:03 am

Re: Image send cue

Post by damien » Wed Jul 17, 2019 12:54 pm

Unfortunately there's not much visibility into the send queue. You can cancel messages in the jmx console via the MoveScu queue: http://localhost:8080/jmx-console/HtmlA ... %3DMoveScu
however, be careful as there is only an option to "Remove all messages", which will cancel everything in the queue. Another caveat is that if something is actively sending it will not be stopped. If that send does not succeed and gets re-queued, you'll have to click "Remove all messages" again when it is not actively sending.

I hope this helps.

mindi2210
Posts: 78
Joined: Tue Mar 04, 2014 2:42 pm

Re: Image send cue

Post by mindi2210 » Wed Jul 17, 2019 2:21 pm

Just to be sure, is the attached photo the area you were talking about? And do the Stop/Start functions (in the next photo) actually start and stop the que?
Attachments
Annotation 2019-07-17 130557.png
Annotation 2019-07-17 130557.png (6.97 KiB) Viewed 11130 times
Annotation 2019-07-17 121603.png
Annotation 2019-07-17 121603.png (3.99 KiB) Viewed 11140 times

damien
Posts: 37
Joined: Fri Jun 07, 2013 7:03 am

Re: Image send cue

Post by damien » Wed Jul 17, 2019 4:25 pm

Yes that's the area I was talking about. I believe that start and stop should start and stop the queue, but do that at your own risk. I've never done that before and am not sure of the ramifications.

mindi2210
Posts: 78
Joined: Tue Mar 04, 2014 2:42 pm

Re: Image send cue

Post by mindi2210 » Wed Jul 17, 2019 5:32 pm

I got an error the first two times I tried to clear the cue and logged in later and the third time it said it worked. It cleared 7 cases that had been sitting, which was what I needed. I just wondered if I stopped the cue, cleared it, and then started it again if that was a better route. Not going to try it though if we do not know how it will affect function.

Locked